T slot clamps

to use your T clamps please follow the steps below. 

1. you will start by threading the hex head bolt into the threaded hole on the brass coloured bar. 

2. you will then insert the black or Brass coloured T bolt into the slotted section on the same brass coloured bar. ( make sure the large section is on the same side as the hex head.) you will then place a washer over this and begin to thread a wing nut onto the opposite end of your T bolt.
3. Lastly you will slide the T slot bolt into the T slow rails nearest your material and tighten the wingnut down in the location you desire to install the clamp.

Please see image below to clarify the correct set up.