MIRA - LED Light bar disconnect from power distribution

Modified on Thu, 25 Aug, 2022 at 9:40 AM

To remove your LED lights you will need to first find your power distribution block.

1. disconnect main power from your machine.
2. remove your left panel cover to expose your power distribution center and your 24 volt power supply.
( for Mira 7 users your power distribution center is located behind the right hand panel near the rear of your machine. see images below)
Mira 7

Mira 9



3. you will then need to locate the wires labeled A-13. you will need to remove this wire and it will remove power from one of the two LED bars. ( please note you will need a 2.5 or 3 mm precision flat head screw driver to remove this cable.) additionally it is always recommended to use electrical tape to cover any exposed wires to prevent shorts.

4. Next you will need to find the 24 volt power supply and remove the red and black wire that are joined together. ( see image for details. ( if the cables are ganged together into the same fork connection you may cut the cable to achieve the same effect.)

again please cover with electrical tape to prevent any shorts.


Was this article helpful?

That’s Great!

Thank you for your feedback

Sorry! We couldn't be helpful

Thank you for your feedback

Let us know how can we improve this article!

Select at least one of the reasons
CAPTCHA verification is required.

Feedback sent

We appreciate your effort and will try to fix the article