Entering your scanning offset adjustment

Modified on Tue, 26 Jul, 2022 at 2:03 PM

The scanning offset settings are etched on the acrylic block. 
To enter the settings you'll have to go into the device settings in lightburn.


In your device settings, you will want to Enable Scanning Offset Adjustment.
The Larger number on the block is the Speed in mm/s and the smaller number is the Lineshift in mm.

When your settings are entered they should look like the below.
(example of a set up for a Mira 7)

Was this article helpful?

That’s Great!

Thank you for your feedback

Sorry! We couldn't be helpful

Thank you for your feedback

Let us know how can we improve this article!

Select at least one of the reasons
CAPTCHA verification is required.

Feedback sent

We appreciate your effort and will try to fix the article