Hello, these are the primary G codes you will need to use with your Masso machine.
Sxxxxx M03 -start spindle
M05- stop
Tx M06- tool change
In addition here is a link to supported G codes for the Masso controller. you may study these and review your G code after you make a program for your machine.
https://docs.masso.com.au/ supported-g-codes
you can also find any post processors you need here.
https://docs.masso.com.au/cam-post-processors
Tx M06- tool change
In addition here is a link to supported G codes for the Masso controller. you may study these and review your G code after you make a program for your machine.
https://docs.masso.com.au/
you can also find any post processors you need here.
https://docs.masso.com.au/cam-post-processors
Was this article helpful?
That’s Great!
Thank you for your feedback
Sorry! We couldn't be helpful
Thank you for your feedback
Feedback sent
We appreciate your effort and will try to fix the article